Filter
Top Products
17
Binary Table
ASCII
Corresponding
RMT16-IR
Button
Binary
Corresponds to
Input
1 1 0011 0001 Input Cycle
2 2 0011 0010 Composite
5 5 0011 0101 Component
6 6 0011 0110 HDMI 1
g 16 0110 0111 HDMI 2
RS232 Settings
Bits per second ................................................................................................. 19200
Data bits .................................................................................................................... 8
Parity .................................................................................................................. None
Stop bits .....................................................................................................................1
Flow Control ....................................................................................................... None
These commands can be used for discrete switching of the listed inputs. To
access the s-video input, use the ASCII command 2 followed by ASCII command
1 to switch to the composite input and then cycle to the s-video input. Likewise, to
access the DVI input, use the ASCII command G followed by ASCII command 1
to switch to the HDMI 2 input and then cycle to the DVI input. There are currently
no discrete commands available to immediately access the s-video and DVI
inputs.
12345
6789
12345
6789
Only Pins 2 (RX), 3 (TX), and 5 (Ground) are used on the RS-232 serial interface
RS-232 SERIAL CONTROL INTERFACE