Filter
Top Products
Figure 4-2. Data Link Status Page
5. Refer to
XTable 4-1X to read the SAT ID/CONNECTIVITY information.
6. Verify radio IDs and signal quality is between 2 – 3. If signal quality is zero, check the antenna and
wiring.
Table 4-1. Data Link Status
SAT ID Field
‘- -‘ GDL 69/69A – 430/530 Series interface communications not yet established.
‘XM’
GDL 69/69A not yet communicating with internal satellite radio hardware (normal
during power-up).
‘X0’, ‘X1’, ‘X2’, or ‘X3’
‘X’ = Satellite radio service activated. Satellite signal quality is indicated by the
numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
‘-0’, ‘-1’, ‘-2’, or ‘-3’
‘-’ = Satellite radio service is not activated. Satellite signal quality is indicated by
the numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
Connectivity Field
“Searching...” No satellite is currently in view, signal quality is ‘0’.
“Satellite in view” Indicates a signal quality between 1 and 3.
4.3 19BVerify XM Subscribed Services
The 430/530 supports the following weather services: NEXRAD, graphical METAR, text-based METAR,
Wind, and Graphical Temperature/Dew Point. These services are available only in the United States.
Verify included services by displaying them on the unit, if applicable. If signal quality is between 1 and
3, but no data is displayed, contact XM Satellite Radio to verify subscription. Be sure that the unit is
updated with the most current software.
Page 14 XM Activation Procedures
190-00355-04 Rev. H