Filter
Top Products
Using the digital surround processor
15
Switching on and off
To switch to standby
● Press Off on the front panel or the remote.
The display will show:
.
If you have other Meridian 500 Series equipment or Meridian
DSP Loudspeakers connected to the digital surround processor
these units will also switch to standby.
When not playing, the digital surround processor should be left
in the standby state. This uses a negligible amount of electricity,
but ensures that the components of the digital surround
processor operate at maximum efficiency from the moment you
start.
If you are not going to use the digital surround processor for
several days you should switch the unit completely off at the
rear panel, and disconnect it from the AC power supply.
To switch on from standby
● Press Source (front panel), or select a source by pressing the
appropriate source key on the remote; eg CD.
If the digital surround processor is part of a Meridian system it
will automatically switch on any other unit in the system, such as
the CD player and Meridian DSP Loudspeakers.