Filter
Top Products
SW6 VGA Audio • Remote Control
Remote Control, cont’d
3-4
SW6 VGA Audio • Remote Control
3-5
Using the command/response table
The command/response table begins on the next page. Lower-
case letters are acceptable in the command field except where
indicated for the gain and attenuation commands. Symbols
are used throughout the table to represent variables in the
command/response fields. Command and response examples
are shown throughout the table. The ASCII to HEX conversion
table below is for use with the command/response table.
Symbol definitions
]
= CR/LF (carriage return/line feed) (0x0D 0A)
• = space
X!
= Input number 0 through 6 (0 = output mute)
X@
= Switch mode 1 = auto switch mode
2 = normal switch mode
X#
= Audio level 0 - 15
X$
= Gain or attenuation -15 through +9
(dBs of gain or attenuation)
X%
= Switch mode 1 = normal switch mode
2 = auto switch mode
X^
= Firmware version n.nn
ASCII to HEX Conversion Table
•
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Switching commands
Select video and audio
input
X!
! C
X!]
Select input
X!
as output.
Example:
6!
C6
]
Select input 6 as output.
Select video input
X!
& V
X!]
Select input
X!
video as output (audio breakaway).
Select audio input
X!
$ A
X!]
Select input
X!
audio as output (audio breakaway).
Switch mode
Set auto switch mode #1
F1
]
Switcher automatically selects the highest numbered
input with a signal present. Front panel and RS-232 input
selection are blocked.
Set manual switch mode #2
F2
]
Switcher responds to front panel/RS-232 input selection.
Input audio level
N
The set gain (G) and set attenuation (g) commands are case sensitive. The show audio level command is not case sensitive.
Set input gain
X!
*
X#
G In
X!
•Aud=
X$]
Set input
X!
audio level to
X$
dB of gain.
Example:
3*6
In1•Aud=+6
]
Set input 1 audio level to +6 dB of gain.
Set input attenuation
X!
*
X#
g In
X!
•Aud=
X$]
Set input
X!
audio level to
X$
dB of attenuation.
Show input audio level
V
X!
G In
X!
•Aud=
X$]
Input
X!
audio level is
X$
of gain or attenuation.
Information requests
Information request I
V
X!
•A
X!
•F
X%
•QVER
X^
•M6
]
Show system configuration and mode. "M" is the total
number of inputs, always 6 for this product.
Request part number N
N60-260-01
]
Query firmware version Q
X^]
Command/response table for SIS commands