Filter
Top Products
Installation, cont’d
MGP 464 • Installation
2-8
PRELIMINARY
You must also configure the LAN port before using it. You can do this by
using SIS commands (see “Command/response table for SIS commands” in
chapter 4, “Software Conguration and Control”) or by using the Comm./IP
Conguration menu on the front panel (see “Comm./IP Conguration menu”
in chapter 3, “Operation”).
LAN port defaults:
MGP’s IP address: 192.168.254.254•
Gateway IP address: 0.0.0.0•
Subnet mask: 255.255.0.0•
DHCP: off•
e
Reset button — Pressing this recessed button causes various IP functions and
Ethernet connection settings to be reset to the factory defaults.
f
Reset LED — This green LED, located to the upper-right of the reset button,
blinks a varying number of times to indicate which reset mode has been
entered. See “Resetting the unit” in chapter 3, “Operation,” for details.
g
BNC output connectors — Plug an output device into these ve BNC
connectors, as shown below.
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGBHV RGBS
RGsB HD YUV Component Video
Connecting to output BNC connectors
h
DVI output — Plug a DVI output device into this
DVI-I connector.
N
Analog RGB is not available on the DVI connector.
N
When two output devices are attached (one to each output connector), they both
display the same image.
i
DVI background input — Connect a DVI input source to this DVI-I connector
in order to display the DVI video source live as a background on your output
screen. The four MGP windows are displayed in front of this DVI image.
When a DVI background is used, the MGP output is locked to the input rate
of the DVI background. This input is not scaled.
N
This input connector can be used only to receive the background image. The
input is not scaled or processed. To process DVI input signals, you must use the
MGP 464 DI model.
DVI-D OUTPUT