Filter
Top Products
17
OPERATING INSTRUCTIONS
• Make sure that you have installed the two “AAA” batteries in the back up
battery compartment.
• Make sure that you have removed the clear plastic battery spacer tab
from the remote control.
• Make sure that you have unwound the FM antenna wire and extended it
to its full length.
NOTE: Unless otherwise specified you may operate this system by pressing
the appropriate buttons on the main unit, or the same buttons on the remote
control handset.
Setting The Time
The first time you connect this system to your AC outlet the display will turn on and
show “AM 12:00” and “1/ 1” (January 1
st
).
The colon will begin to flash indicating that
the clock is running.
1.) Press the Mode button 3 times. The
time display will begin to flash.
2.) Press the TUN + or TUN – buttons to set the Hour display forward or backward
to the correct hour. Example: PM 2:00.
Be sure to observe the AM or PM
indicator to confirm that you have set
the hour correctly.
3.) Press the Volume + or Volume –
buttons to set the Minute display
forward or backward to the correct
minute. Example: PM 2:45.
4.) Within 10 seconds after you adjust the time the display will stop flashing and
the clock begins to run.
NOTE: If the display stops flashing before you finish setting the correct
time, your setting will not be completed. If this occurs, repeat steps 1 through 3
and be sure to complete your settings while the display is still flashing.
iE600_050407.p65 4/5/2007, 11:5017