Filter
Top Products
22
5.) Close the CD door. The disc will spin and zeros will flash in the track number
and time display. Within a few seconds the disc will stop spinning and the
display will show the total playing time and total tracks on the disc.
Note: If the disc is inserted upside down or if the disc is badly scratched
and unreadable, playback will
not be possible. In this case the
main display will show “no
dISC”. Remove the disc and re
insert it properly, or try another
disc.
6.) Press the PLAY/PAUSE button on the front panel of the main unit or on the
remote control to begin playback
on track 1. The display will show
the elapsed playing time of each
track as it plays.
7.) Adjust the MAIN VOLUME and VARIABLE BASS VOLUME level controls as
desired.
8.) When the last track has played the player stops automatically and the display
again shows the total playing time
and tracks on the disc. You may
also stop playback at any time by
pressing the STOP /BAND
button on the front panel of the
main unit or on the remote control.
9.) When you are finished listening press on the front edge of the CD door to
open it. Remove your disc and close the CD door.
10.)Press the STANDBY/ON button to return the system to the STANDBY (Power
Off) mode.
ES20_ib061303.p65 13/6/2003, 12:1322