Filter
Top Products
MODEL 5081-P-FF/FI INSTALLATION
6
INSTALLATION
UNPACKING AND INSPECTION
Inspect the shipping container. If it is damaged, contact the
shipper immediately for instructions. Save the box. If there
is no apparent damage, unpack the container. Be sure all
items shown on the packing list are present. If items are
missing, notify Rosemount Analytical immediately.
ROTATING THE DISPLAY
The 5081-P-FF/FI display can be rotated 90° left or right.
Disengage the cover lock and remove the front cover.
Remove the three screws holding the PCB stack and gen-
tly lift the display board. Do not disengage the ribbon cable
between the display board and the CPU board. Rotate the
display. The black infrared sensor will be at the top of the
display.
INSTALLATION
See Figure 6.
1. Although the analyzer is suitable for outdoor use, do not
install it in direct sunlight or in areas of extreme temper-
atures.
2. Install the analyzer in an area where vibrations and elec-
tromagnetic and radio frequency interference are mini-
mized or absent.
3. Keep the analyzer and sensor wiring at least one foot
from high voltage conductors. Be sure there is easy
access to the analyzer.
4. The conduit connections on the sides of the 5081-P
housing should be sealed to prevent moisture from
entering the enclosure.
5. The transmitter must not be mounted with both conduit
openings at the top.
MILLIMETER
INCH
FIGURE 6. Mounting Model 5081-P-FF/FI