Filter
Top Products
3
MODEL 5081-P-FF/FI WIRING
SENSOR WIRING AND SET-UP
Wire sensor per Figure 1. Refer to the sensor instruction
manual for more details.
If your sensor has an integral preamplifier or you are using
a remote preamplifier, you will need to change the pream-
plifier location in the program menu. Please see Figure 14.
Select “trAnS” for integral preamplifier or “SnSr” for J-box
or sensor preamplifier.
WIRING THROUGH A JUNCTION BOX WITH
REMOTE PREAMPLIFIER
Wire sensor as shown in Figure 5. Refer to the sensor
instruction manual for more details.
WIRING THROUGH A JUNCTION BOX
Sensors with integral preamplifiers can be wired to the ana-
lyzer through a remote junction box (PN 23550-00). Wire
the extension cable and sensor cable point-to-point. Refer
to the sensor instruction manual for more details.
POWER WIRING
For general purpose areas, wire power as shown in
Figure 1. For hazardous areas, please see hazardous
area installation drawings.
FIGURE 1. Model 5081-P-FF/FI Wiring Details
(9 - 32 VDC)
NOTE: REF wire covered with
sleeving. To prevent
depletion of KCL if
other wires touched,
remove sleeving
before wiring to TB-7.