Filter
Top Products
Network configuration
29
NetMax N8000 System Controller
Owner’s manual
8. Close the window Internet Protocol (TCP/IP) Properties by clicking on the OK button.
The IP configuration of the PC is now complete. In the following steps the connection of the
PC with the N8000 will be established and checked.
9. Connect the network connection of your PC to the Ethernet interface of the N8000
directly with a crossover cable, or with a patch cable and a hub/switch.
Please see the Ethernet principles chapter on page 33 in the appendix of this document for
more information on the details of connecting devices via Ethernet.
10. Connect the N8000 to the power supply system and switch it on by operating the
power switch on the rear.
The green ON-LED (see page 11) on the front panel of the N8000 is illuminated. After some
seconds the green READY-LED (see page 11) is also illuminated and signals the successful
start activity of the N8000.
11. Click on Start > All Programs > Accessories > Command Prompt.
The window command prompt appears.