Filter
Top Products
SMARTNET/SMARTZONE FEATURES
40
2. Enter the index of the desired ID if you know it or scroll through the list
using the and keys until you find the desired ID. Press the
CLR
key to cancel the call.
3. Press the PTT switch to initiate the call. The display then indicates the
alias of the destination radio. Wait approximately 1 second and then
begin talking. Proceed to the bulleted list which follows the next
method for conditions that may then occur.
Direct Entry Method (Full Keypad Models Only)
1. With a SMARTNET/SmartZone channel selected, press and hold the
Private Call option switch until a tone sounds (approximately 1
second). The last ID called is displayed and the private call mode is
indicated by “
C” in the upper part of the display.
2. Using the 0-9 keys, enter the 6-digit ID of the unit you are calling. Press
the key to erase the last digit entered or press the
CLR key to cancel
the call.
3. Press the PTT switch to initiate the call. If the entered ID is invalid,
“INVALID” is momentarily displayed and the call is not initiated. If the
entered ID is valid, the display indicates the alias of the ID if it matches
an ID in your call list. Otherwise, the ID you entered continues to be
displayed. Wait approximately 1 second and then begin talking. Any of
the following conditions may then occur.
• If the called party answers and the call is successful, the person’s
voice is heard and the call is carried on the same as a group call. To
end the call at any time, press the
CLR key.
• If the radio system is busy, four low tones sound and the “BUSY” and
“WAIT” are alternately displayed. When the system is no longer busy,
the call back tone (four beeps) is heard and a channel is automatically
acquired. Press the PTT switch to continue the call.