Filter
Top Products
SMARTNET/SMARTZONE FEATURES
38
• If the called party answers but the radio system is busy, four low tones
sound and “BUSY” and “WAIT” are alternately displayed. When the
system is no longer busy, the called party automatically responds.
• If an out-of-range condition exists or the radio system is not in
service, “LOST CALL” is displayed and a continuous tone sounds.
End the call by pressing the
CLR key.
Receiving an Enhanced Private Conversation Call
These calls are automatically received if a SMARTNET/SmartZone
channel is selected. Proceed as follows:
1. When a call is received, a recurring unit call tone (three beeps) sounds
for up to 20 seconds, and “CALL RCV” and the current channel alias
are alternately displayed.
2. To answer the call, press the Private Call option switch and then the
PTT switch and begin talking. The private call mode is indicated by
“
C” in the upper part of the display. The alias of the incoming call is
displayed if the ID is in your call list. Otherwise, the unit ID is
displayed. NOTE: If the Private Call option switch is not pressed before
the PTT switch, a group call is transmitted on the selected group.
• To end the call when the conversation is complete or at any other time,
press the
CLR key.
• If unit-to-unit (private) calls are not permitted (Private Call switch not
programmed), press the Call Response option switch, if available, to
answer the call.
• If the call is not answered within 20 seconds, it is automatically
terminated.
• If the radio system is busy, four low tones sound and “BUSY” and
“WAIT” are alternately displayed. When the system is no longer busy,