Filter
Top Products
CONVENTIONAL FEATURES
30
opposite occurs with the low power setting. When the low power is
selected on the current channel, “LOW” is indicated continuously near
the bottom of the display.
Pressing the High/Low Power switch toggles the power setting. The
new level is flashed in the display when this switch is pressed as “HI
POWER” or “LO POWER”. If power selection is not permitted on the
channel, the fixed power level is flashed and no power change occurs.
Turning power off or changing channels does not change the power
setting selected for a channel.
Conventional Mode Scanning
General
The following information describes scanning features unique to
conventional operation. Scan operation common to all modes is described
starting on page 20, and scan operation unique to SMARTNET/
SmartZone operation is described starting on page 48.
Selecting a Scan List
When standard scanning with full keypad (15-key) models, one of
up to three scan lists can be selected. These lists can be dealer or user
programmed as described in the information which follows. With limited
keypad (3-key) models, only one scan list is available and it cannot be
user programmed. However, nuisance channels can still be temporarily
deleted as described on page 23.
Proceed as follows to select a scan list with full keypad models:
1. Press the Scan option switch to enable scanning. The currently selected
scan list is momentarily indicated as “Scan x”, where “x” is the list
number (1-3).
2. To select one of the other lists, press the number key corresponding to
the desired list (1-3) and the selected list is then momentarily displayed
as “Scan x”. The selected scan list is stored in memory and does not
change until this procedure is repeated.