Filter
Top Products
SMARTNET/SMARTZONE FEATURES
45
2. Using the 0-9 keys, enter the 6-digit ID of the unit you are calling. Press
the key to erase the last digit entered or press the
CLR key to cancel
the page.
3. Press the PTT switch or the
ENT key to send the page. If the entered ID
is invalid, “INVALID” is momentarily displayed and the page is not
sent. If the entered ID is valid, the display indicates the alias of the ID
if it matches an ID in your call list. Otherwise, the ID you entered
continues to be displayed. The page is then sent and any of the
following conditions may then occur.
• If the radio you are paging is on the air and received your page, a
signaling success tone (six beeps) sounds and the display momentarily
indicates “ACK RCVD”. The alias of the selected channel is then
displayed continuously.
• If the radio you are paging is not in service, a tone sounds and “NO
ACK” is displayed. Press the
CLR key to cancel the page.
Answering a Page
1. When a page is received, the display alternately indicates “PAGE
RCV” and the alias of the current channel and a recurring received page
tone sounds (six beeps) sounds.
2. To clear and ignore the page, press the
CLR key. NOTE: If the CLR key
is programmed for the Private Call function, it will not clear the page.
3. Answering a page is the same as placing a private call. Therefore, press
the Private Call option switch and follow the instructions for placing a
private call on page 36 or page 39, whichever is applicable.
Messaging
The messaging feature allows preprogrammed messages to be sent
to your dispatcher. Up to 16 messages can be preprogrammed, and they
are identified by a tag (alias). If a Message option switch is programmed,
messages are sent as follows: