Filter
Top Products
GENERAL OPERATION
23
Determining Which Channels are in Scan List
Channels in the standard SMARTNET/SmartZone and radio wide
lists are not indicated. With conventional channels, the selected channel
is in the current scan list if the box icon (around “
S”) is indicated in
the upper left corner of the display.
Nuisance Channel Delete
With standard scanning, channels can be temporarily deleted from
the scan list, for example, if messages on a channel become annoying.
This feature is not available with radio wide scanning. Proceed as follows:
NOTE: The selected channel and conventional priority channels cannot
be deleted from the scan list.
1. While receiving a message on the channel to be deleted, press and hold
the Scan option switch until the alert tone sounds (about 1 second).
2. The channel is then deleted and scanning of the remaining channels in
the scan list resumes.
3. Deleted channels are added back into the scan list if either of the
following occur:
• Scanning is turned off and then on again using the Scan switch.
• Transceiver power is turned off and then on again.
Conventional and SMARTNET/SmartZone Operation
Introduction
Each selectable channel is dealer programmable for either conven-
tional or SMARTNET™/SmartZone® (trunked) operation. For example,
Zone 1/Channel 1 could be a conventional channel, Zone 1/Channel 2 a
SMARTNET/SmartZone channel, and so on. Consult your dealer to
determine the type or types of operation programmed in your radio. More
information on these modes follows.