Filter
Top Products
GENERAL OPERATION
21
wide scanning is occurring, radio wide scanning is automatically disabled
and vice versa. More information on these modes follows.
Standard Scanning
Standard scanning monitors only channels that are the same type as
that currently selected. Therefore, if a conventional channel is selected,
only conventional channels are scanned, and if a SMARTNET channel is
selected, only SMARTNET channels are scanned. Standard scanning is
turned on and off by the Scan option switch as follows. If this switch is
not programmed, standard scanning is not available.
• To turn standard scanning on, press the Scan option switch. Scanning is
enabled when the “
S” icon is indicated in the upper left corner of the
display and SCAN x (conventional) or SCAN ON (SMARTNET/
SmartZone) is briefly displayed. The “x” is the number of the conven-
tional scan list (1, 2, or 3) that is selected. Refer to page 30 for more
information.
• To turn scanning off, press the Scan option switch again. The “S” icon
is then no longer indicated and “SCAN OFF” is briefly displayed.
• If the zone or channel is changed while scanning is selected, scanning
continues on the same or a different scan list (see scan list information
which follows).
Radio Wide Scanning
Radio wide scanning monitors the channels in the preprogrammed
radio wide scan list (see page 22). This list may contain up to 16 channels
of any type (conventional or SMARTNET/SmartZone) assigned to any
zone. Radio wide scanning is turned on and off by the Radio Wide Scan
option switch as follows. If this switch is not programmed, radio wide
scanning is not available.
• To turn radio wide scanning on, press the Radio Wide Scan option
switch. The icon is then displayed continuously and “RWS ON” is
displayed briefly.