Filter
Top Products
38
ENGLISH
Condensation Setup Precautions
2 Condensation
Condensation can be seen as water droplets that have
formed on the windows of a heated room in winter.
2 Conditions for the Formation of Condensation
In winter, when the unit is brought from outdoors to a
warm indoor location, or when the room temperature is
suddenly raised by a heater, condensation will form on the
operating parts within the unit and normal operation will
no longer be possible.
Condensation can also form in summer when the breeze
from an air conditioner strikes the unit directly. Should this
occur, change the setup location of the unit.
2 Measures to Take After Condensation Forms
• If condensation has formed, switch on the power and
leave the unit for a while. Although the time will differ
according to the surrounding conditions, the unit should
be usable in 1 to 2 hours.
• Should condensation form on the disc, wipe the disc
clean.
Other Precautions
2 Illustrations used for descriptive purposes may differ from
the actual items.
2 Please keep the instruction manual.
After reading this instruction manual, please keep it in a
safe place together with the warranty. It is also convenient
to enter the required items into the columns on the rear
cover.
Please provide a spacing of more than 10 cm between the
top, rear, and side surfaces of this unit and walls or other
audio/video equipment, etc.
2 When using this unit or other electronic equipment that
contains microprocessors at the same time as using a
tuner or TV, noise or screen interference can occur on the
audio and video of the tuner or TV. Should this occur, pay
careful attention to the following points.
• Separate this unit as much as possible from the tuner or
TV.
• Separate the antenna line of the tuner or TV from the
power cable and input/output connection cables of this
unit as much as possible.
• Use of indoor antennas and 300 Ω/ohm feedline are
especially susceptible to such interference. We
recommend the use of outdoor antennas and 75 Ω/ohm
coaxial cable.
300 Ω/ohm feedline 75 Ω/ohm coaxial cable
When not using the D-A03
2 Under normal circumstances
• Always remove the disc and turn the power off.
• When leaving home for long periods of times such as
for trips, be sure to unplug the power cord.
2 When moving the D-A03
• Do not subject the D-A03 to
shocks.
• Always check that the disc has
been removed and the connection
cords disconnected before moving
the D-A03.