Filter
Top Products
89
HDMI control function
If the HDMI control function does not operate properly, check the
following points.
•Is the TV or player compatible with the HDMI control function?
•Is “HDMI Control” (vpage108) set to “On”?
•Is “Power O Control” (vpage108) set to “All” or “Video”?
•Are the HDMI control function settings of all devices correct?
NOTE
•When “HDMI Control” is set to “On”, it consumes more standby
power.
•The HDMI control function controls operations of a TV that is
compatible with the HDMI control function. Make sure that the TV
and HDMI are connected when you perform HDMI control.
•Some functions may not operate depending on the connected TV
or player. Check the owner’s manual of each device for details
beforehand.
•When “Power O Control” on the menu is set to “O”
(vpage108), this unit is not set to standby even if the connected
device is in the standby mode.
•When connection changes are implemented, such as adding
connections to HDMI devices, linked operations may be initialized.
In this case, you will need to reconfigure the settings.
•When “HDMI Control” is set to “On”, it is not possible to assign an
HDMI connector to “TV AUDIO” at “Input Assign” (vpage112).
•Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat steps 2 and 3.
•“Input Assign” – “HDMI” (vpage112) setting has changed.
•There is a change to the connection between the devices and the
HDMI, or an increase in devices.
Sleep timer function
•You can have the power automatically switched to standby once a
set time has elapsed. This is convenient for viewing and listening
while going to sleep.
•The sleep timer function can be set for each zone (vpage 94
“Sleep timer function”). (The MAIN ZONE setting method is
explained here.)
1
Press MAIN to switch the zone
mode.
MAIN lights.
2
Press SLEEP and display the time you want to set.
The SLEEP indicator on the display lights.
•The time switches as shown below each time
SLEEP is pressed.
Off 10 min 20 30 40 50
6080 7090100
110
120
To confirm the countdown time before putting the
unit to sleep
Press SLEEP.
“Sleep : zmin” appears on the display.
z Countdown time
To cancel the sleep timer
Press SLEEP to set “O”.
The SLEEP indicator on the display turns o.
•The sleep timer setting is canceled if this unit’s power is set to
standby.
•The sleep timer function can be set separately for the dierent zones
(vpage94 “Sleep timer function”).
NOTE
The sleep timer function cannot turn o the power of devices
connected to this unit. To turn o the power of those connected
devices, set up sleep timers on the connected devices themselves.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD