Denon AVRE400 Stereo Receiver User Manual


  Open as PDF
of 159
 
101
Surround Parameter
Default settings are underlined.
You can adjust the surround audio sound field eects to match your preferences.
The items (parameters) that can be adjusted depend on the signal being input and the currently set
sound mode. For details on the adjustable parameters, see “Sound modes and surround parameters”
(vpage136).
NOTE
•Some setting items cannot be set while playback is stopped. Make the settings during playback.
•When the sound mode is “PURE DIRECT”, you cannot set the surround parameters.
Setting items Setting details
Cinema EQ
Gently softens the upper
treble range of movie
soundtracks to reduce
possible harshness and
improve clarity.
On : “Cinema EQ” is used.
O : “Cinema EQ” is not used.
Loudness Management
This can be set in the
Dolby TrueHD mode.
This sets whether to
output as specified in
“Dynamic Compression”
or output directly without
compressing the dynamic
range of audio recorded in
the disc.
On : Outputs using the settings made in “Dynamic Compression” and
“Dialogue Normalization” (vpage126) are enabled.
O : “Dynamic Compression” settings and “Dialogue Normalization” are
disabled, and the signals on the disk are output as is.
Dynamic Compression
Compress dynamic range
(dierence between loud
and soft sounds).
Auto : Automatic dynamic range compression on/o control according to
source.
Low / Medium / High : These set the compression level.
O : Dynamic range compression is always o.
You can set “Auto” only for the Dolby TrueHD source.
Dialog Level
Default settings are underlined.
Adjusts and enhances the frequency band corresponding to the human voice at the center channel to
make the voice clearer.
Setting items Setting details
Level
–12dB – +12dB (0dB)
Subwoofer Level
Default settings are underlined.
This setting adjusts the volume level for the subwoofer.
Setting items Setting details
Subwoofer
Turn subwoofer output on
and o.
On : The subwoofer is used.
O : The subwoofer is not used.
NOTE
This can be set when the sound mode is “DIRECT” and “PURE
DIRECT” (vpage 71) and the “Subwoofer Mode” (vpage 118) is
“LFE+Main”.
Subwoofer Level
This setting adjusts the
volume level for the
subwoofer.
–12dB – +12dB (0dB)
Audio
Basic instructions
Advanced instructions
Information
Advanced instructions
v See overleaf
DVD
 previous next