Denon AVRE300 Stereo Receiver User Manual


 
104
Network
Settings
Make settings for wired LAN.
Only set “Settings” when connecting to a network without a DHCP function.
Setting details
Information
Network
IP Control
Friendly Name
Settings
Diagnostics
q
DHCP
Settings
-IP Address
-Subnet Mask
-Default Gateway
-Primary DNS
-Secondary DNS
Off
192.
168.
000.
001
255.
255.
255.
000
000.
000.
000.
000
000.
000.
000.
000
000.
000.
000.
000
Proxy
-Name
-Port
Off
00000
Save
Cancel
e
y
i
t
w
o
Q1
r
u
Q0
q On the menu, select “Network” – “Settings” and press ENTER.
w Use ui to select “DHCP”, then press ENTER.
e Use o p to select “O”, then press ENTER.
r Use ui to select “IP Address”, then press ENTER.
•IP Address : Set the IP address within the ranges shown below.
The Network Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.1 – 10.255.255.254
CLASS B: 172.16.0.1 – 172.31.255.254
CLASS C: 192.168.0.1 – 192.168.255.254
t Use uio p to input the address and press ENTER.
y Use ui to select setting item, then press ENTER.
•Subnet Mask : When connecting an xDSL modem or terminal adapter directly to this unit, input the
subnet mask indicated in the documentation supplied by your provider. Normally input 255.255.255.0.
•Default Gateway : When connected to a gateway (router), input its IP address.
•Primary DNS, Secondary DNS : If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If two or more DNS are provided by your
provider, enter both “Primary DNS” and “Secondary DNS”.
Setting details
u Use ui to select “Proxy” and press ENTER.
•Proxy : Make this setting when connecting to the Internet via a proxy server.
Make the proxy settings only when you connect to the Internet via a proxy server that is on your
internal network or provided by your provider, etc.
i Use o p to select “On(Address)” or “On(Name)”, and then press ENTER.
On(Address) : Select when inputting by address.
On(Name) : Select when inputting by domain name. Up to 38 characters can be input.
o Press i to select “Address” or “Name”, then press ENTER.
When “Address” is selected in step i : Use uio p to enter the proxy server address, and press
ENTER.
When“Name” is selected in step i : Use the software keyboard (vpage84) to enter the domain
name, and select
O K
.
•For character input, see page84.
Q0 Press i to select “Port”, then press ENTER. Use uio p to input the proxy server port number and
press ENTER.
Setup is complete.
Q1 Press i to select “Save”, then press ENTER.
The display returns to the original screen.
•If you are using a broadband router (DHCP function), there is no need to make the settings at “IP
Address” and “Proxy”, since the DHCP function is set to “On” in this unit’s default settings.
•If this unit is connected to a network without the DHCP function, the network settings must be made.
In this case, some knowledge of networks is required. For details, consult a network administrator.
•If you cannot connect to the Internet, recheck the connections and settings (vpage18).
•If you do not understand about Internet connection, contact your ISP (Internet Service Provider) or the
store from which you purchased your computer.
•When you want to cancel the setting during IP address input, select “Cancel”, then press ENTER.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD