Filter
Top Products
Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
j
Remote ID Setup
Set remote control ID.
k
2Way Remote
Make setting for 2-way remote control unit.
[Selectable items]
1
2
3
4
[Selectable items]
Used
: Use 2-way remote control.
Not Used
: Do not use 2-way remote control.
When using a 2-way remote control unit (RC-7000CI and RC-7001RCI,
sold separately), set this to “Used”.
l
Display
Adjust display brightness of the receiver.
Operating from the remote control unit
Press the DIMMER button.
Bright Dim
DarkOFF
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
NOTE
When using the AVR-2308 with only the included remote control unit
(RC-1081), there is no need to make settings.
When using a separately sold remote control unit (RC-7000CI, etc.),
this function can be used. Match the ID setting of the remote control
unit and the receiver.
A0
Setup Lock
Protect settings from inadvertent change.
• When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.
⋅ Menu operations
⋅ RESTORER
⋅ Night Mode
⋅ Parameter
⋅ Room EQ
⋅ Channel Level
⋅ Audio Delay
• To cancel the setting, press the MENU button to re-display the “Setup
Lock” screen, then change the setting to “OFF”.
[Selectable items]
ON
: Turn protection on.
OFF
: Turn protection off.
Setup