Filter
Top Products
ENGLISH
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
Specifi cations
iPod
®
Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q Set the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod’s operating instructions.)
w Assign the control dock for iPod’s input.
The input for the control dock for iPod is assigned to VCR by
default.
MENU : ”Input Setup” – “Assign” – ”iPod Dock”
(vpage 34)
2
Either turn <SOURCE SELECT> or press [iPod] to
select the input source assigned in step 1-w above.
(iPod screen)
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “iPod/NETWORK”.
(vpage 56 “Remote Control Unit Operations”)
Basic Operation
OK to disconnect.
ENTER, op<ON/STANDBY>
<SOURCE SELECT>
<STATUS> ui
uiop
[SOURCE
CONTROL 1]
[6, 7]
[iPod]
[OFF]
[1]
[SOURCE
CONTROL 2]
[2]
[8, 9]
ENTER
uiop
[iPod]
[MODE]
[TUNING +/–]
ENTER
[Front]
[Rear]
4
Press [MODE] and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, “Remote” is displayed.
[Selectable mode]
Browse mode Remote mode
Display location Main unit display
iPod display
Playable
files
Audio file
S S
Video file
S
z
1
S
z
2
Active
buttons
Remote
control unit
(AVR-889)
S S
iPod
A S
z
1 :
When using an ASD-3N or ASD-3W control dock for iPod.
z
2 : Video may not be output, depending on the combination of ASD-1R
or ASD-11R and iPod.
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is “Mode3” (vpage 43).
• Press <ON/STANDBY> or [OFF] and set the AVR-889’s power to the
standby mode before disconnecting the iPod. Also switch the input
source to one to which the menu “iPod Dock” is not assigned before
disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
Playback
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
1.AVR889_ENG_107.indd 54 2008/08/01 11:37:38