Denon AVR-788 Home Theater System User Manual


 
ENGLISH
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can tune
them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
Press [MEMORY].
3
Press SHIFT to select the block (A to G) in which the
station is to be preset.
4
Press PRESET CHANNEL to select the preset number
(1 to 8).
5
Press [MEMORY] again to complete the setting.
• To preset other stations, repeat steps 1 to 5.
• Stations can be preset automatically at menu “Input Setup” – “Auto
Preset” (vpage 31).
NOTE
Preset stations are erased by overwriting them.
1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [MODE SELECTOR 1] to “AUDIO”.
(vpage 48 “Remote Control Unit Operations”)
3
Press BAND to select “FM” or “AM”.
4
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press [MODE] to light the “AUTO” indicator on the display, then use
TUNING to select the station you want to hear.
w To tune in manually (Manual Tuning)
Press [MODE] to turn off the display’s “AUTO” indicator, then use
TUNING to select the station you want to hear.
Listening to FM/AM Broadcasts
It is also possible to switch to “FM” or “AM” in step 1 by pressing
[TUNER].
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold TUNING to change
frequencies continuously.
• The time for which the on-screen display are displayed can be set at
“Manual Setup” – “Option Setup” – “On-Screen Display” (vpage
29).
Basic Operation
1
Press SHIFT to select the memory block (A to G).
2
Press PRESET CHANNEL to select the desired preset
channel (1 to 8).
n Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 107.9 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
520 / 600 / 1000 / 1400 / 1500 / 1710 kHz,
90.1 / 90.1 MHz
C1 ~ C8
90.1 MHz
D1 ~ D8
90.1 MHz
E1 ~ E8
90.1 MHz
F1 ~ F8
90.1 MHz
G1 ~ G8
90.1 MHz
Playing Video and Audio Equipment
1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor’s operating instructions.)
2
Use SOURCE SELECT to select the input source.
3
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
(vpage 48 “Remote Control Unit Operations”)
4
Set [MODE SELECTOR 2] to the component you want
to operate.
5
Start playback.
(vSee the operating instructions of the respective devices.)
Basic Operation

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
Listening to Preset Stations
1.AVR788E3_ENG_108.indd 45 2007/10/05 16:22:29