Filter
Top Products
29
ENGLISH
Basic versionSimple version InformationAdvanced version
Connect
2.1-channel/2-channel connection
FL FR
SW
2-channel connection
For 2-channel playback, disconnect the
subwoofers.
1
Set up
the remote control unit
n Set up the operation mode
Press AMP to set the remote
control unit to amplier
operation mode.
Press AMP
2
Connect the setup microphone.
3-1.Audyssey Auto Setup
MultEQ
at ear height at
Normal
Pre Assign:
Start
Cancel
[ENT]:Select [RTN]:Back
Please place microphone
main listening position.
When the setup microphone is
connected, the following screen is
displayed.
3
Use ui to select “Pre Assign”.
3-1.Audyssey Auto Setup
MultEQ
at ear height at
Normal
Pre Assign:
Start
Cancel
[RTN]:Back
Please place microphone
main listening position.
Set up speakers
around items indicate the settings.
Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see “Simple version”, “Set up speakers (Audyssey
®
Auto Setup)” (vpage6).
First install and connect the speakers to this unit.
4
Use o p to select the
conguration of the connected
speakers.
Normal
Set for connecting the
surround Back speakers to
the SURR. BACK/FRONT
HEIGHT connector in PRE
OUT.
Front Height
Set for connecting the
front height speakers to
the SURR. BACK/FRONT
HEIGHT connector in PRE
OUT.
5
Proceed to page 8
“
Preparation
” step 5.
NOTE
After performing Audyssey Auto Setup,
do not change the speaker connections or
subwoofer volume. In event of a change,
perform Audyssey Auto Setup again.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu