Filter
Top Products
38
3
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
2
The volume can be adjusted within the range of –60 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 22 or pages 43 and 44, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is “18 dB — (Maximum value of channel level)”.)
Input mode display
ANALOG DIGITAL
DIGITAL
DIGITAL
DIGITAL
ANALOG
• In the DIGITAL AUTO mode
• In the DIGITAL PCM mode
• When switched to RF in the VDP RF or AUTO mode
• In the ANALOG mode
Input signal display
DIGITAL PRO LOGIC
LOCK
L
C
R
SL
S
SR
CH INDICATOR
LOCK
LFE
LOCK
L
C
R
SL
S
SR
CH INDICATOR
LOCK
LFE
L
C
R
SL
S
SR
CH INDICATOR
LOCK
LFE
LOCK
One of these lights, depending on the
input signal.
One of these lights, depending on the
input signal.
• DTS
Lit
• PCM
2
The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 25) and connections are correct and
whether the component’s power is turned on.
Select the play mode.
STEREO
(Main unit) (Remote control unit)
Example: Stereo
(Main unit) (Remote control unit)The volume level is
displayed on the
master volume level
display.
NOTE:
• The digital input indicator will light (green) when playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in
the “ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DIGITAL”.
STEREO
MASTER VOLUME
MASTER VOL.
• In the AUTO mode
• DOLBY DIGITAL