Filter
Top Products
34
System call function
• The included remote control unit is equipped with a system call function for transmitting multiple remote control signals when a single button
is pressed (this is often referred to as a “macro” function).
This function can be used to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on a source
component’s power and start playback, etc., all at the touch of a button.
(1) System call buttons
The buttons that can be used for the system call function are shown on the table below.
A series of up to 10 operations can be performed with the POWER ON and OFF buttons, and a series of up to 5 operations can be performed
with other buttons.
System call signals are already preset at the buttons indicated in the shaded section. System call signals can also be stored at any button on
the remote control unit, including the buttons in this section. (See page 35.)
Button
POWER OFF
(key 3)
POWER OFF
(key 4)
DVD (key 5)
VDP (key 6)
TV/DBS
(key 9)
V.AUX
(key 10)
VCR-1
(key 13)
CD (key 14)
No.
transmissions
10
10
5
5
5
5
5
5
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
Receiver
power on
DVD player
(DVD)
power on
LD player
(VDP)
power on
TV power on
TV power on
Video (VCR)
power on
Receiver
input source
switched to
CD
Receiver
input source
switched to
DVD
Receiver
input source
switched to
VDP
Receiver
input source
switched to
TV/DBS
Receiver
input source
switched to
V.AUX
Receiver
input source
switched to
VCR-1
TV power on
Video (VCR)
playback
TV power on
TV power on
DVD player
(DVD)
playback
LD player
(VDP)
playback
Stored
operation 1
Stored
operation 2
Stored
operation 3
Stored
operation 4
Stored
operation 5
Stored
operation 6
Stored
operation 7
Stored
operation 8
Stored
operation 9
Stored
operation 10
The system call signals for the POWER OFF and
POWER ON buttons are transmitted from the
remote control unit approximately once every
second.
The signals for the other buttons (DVD, VDP,
TV/DBS, V.AUX, VCR-1 and CD) are transmitted
approximately once every 1.5 seconds.
(2) Using the system call function
1
2
Press the system call button.
• The LEARNED/TX LED flashes for 5 seconds.
Press the button at which the desired system call signals are
stored while the LEARNED/TX LED is flashing.
• The preset signals or the signals you have stored at that
button are transmitted in succession.
CALL
DVD
START LEARNED/TX
HOME THX CINEMA
TUNING
BAND
TITLE
MENU/GUIDE
MODE
DOLBY / DTS
SURROUND
DIRECT
DSP SIMULATION
5CH STEREO STEREO
INPUT MODE
ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS V.AUX PHONO
VCR-1 CD
MD
/
TAPE-1
CHANNEL
VCR-2
TAPE-2 MON
TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MD
LOCK
DECK
SYSTEM
SETUP
SURROUND
PARAMETER
CH SELECT
RC-853
123
4
SET
A / B
CALL OFF
ENTER
ON
/
SOURCE
56
789
+10
0
2
1