Filter
Top Products
- 4 -
Before Use
Before Connection
CAUTION
Turn off the power of all the equipment before mak-
ing connections.
Read instructions of each component you intend to
use with this unit.
< Be sure to insert each plug securely. To prevent
hum and noise, do not bundle the connection
cords with the power cord or speaker cord.
Back-up Memory Function
This is the function which preserves the preset mem-
ory and most-recent memory functions. In the event
of a power failure, or if the power cord of this unit is
disconnected from the electric outlet, the back-up
memory will preserve the preset memory and most-
recent memory functions for as long as approximate-
ly 15 days.
If the power supply is interrupted for 15 days or
longer, the memory settings will be erased.
When to Use RESET
< When this system is subjected to an electrical
shock.
< When the power is irregular.
In these cases, try the following
Press the ENTER button for more than 5 seconds.
Note:
If the ENTER button is pressed for more than 5
seconds Standby mode, all the memory will be
erased.
Read this before operation
< As the unit may become warm during operation,
always leave sufficient space above the unit for ven-
tilation.
< The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
< Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source
of heat. Also avoid locations subject to vibrations
and excessive dust, heat, cold or moisture.
< Do not open the cabinet as this might result in dam-
age to the circuitry or electrical shock. If a foreign
object should get into the set, contact your dealer.
< When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
< Do not attempt to clean the unit with chemical sol-
vents as this might damage the finish. Use a clean,
dry cloth.
< Keep this manual in a safe place for future reference.