Crestron electronic CNAMPX-2X60 Stereo Amplifier User Manual


 
Crestron
CNAMPX-2X60
2 Channel Professional Audio Amplifier
CNAMPX-2X60 Front Panel Power Switch
As shown below, the front panel of the CNAMPX-2X60 contains a power switch
with an LED indicator. This two-position (ON/OFF) switch enables operating power
to the CNAMPX-2X60 circuitry. It must be positioned to ON when the unit is to be
controlled by the control system. When the Cresnet system 24VDC is applied to the
NET connector on the rear panel and the switch is set to ON, AC power is applied to
the unit and the LED (green) illuminates.
CNAMPX-2X60 Front Panel
CNAMPX-2X60
POWER
P R O F E S S I O N A L A U D I O A M P L I F I E R
2 C H A N N E L 6 0 W A T T
CRESTRON
Leading Specifications
The table below and continued on the next page provides a summary of leading
specifications for the CNAMPX-2X60.
Leading Specifications of the CNAMPX-2X60
SPECIFICATION DETAILS
Power Input Requirements: US version 120VAC +/-10%, 50-60Hz, 960 Watts
International version 230VAC +/-10%, 50-60Hz, 960 Watts
Cresnet Power Requirements 3 Watts (24VDC @ 0.125A)
Default NET ID 3F
Channels 2 Unbridged; 1 Bridged
60 Watts/Channel
into 8-ohm loads
90 Watts/Channel
into 4-ohm loads
200 Watts/Channel Bridged into 8-ohms
Input Impedance 28Kohms
Power Bandwidth - 3dB 3Hz to 50KHz
Frequency Response @ 1W 8ohm Flat +0, -0.1dB from 20Hz to 20KHz
THD @ full power
0.03% or less
SMPTE I.M. Distortion
0.03% or less
Signal to Noise Ratio (S/N) "A" Weighted >110dB
Gain 28dB
Damping Factor >400
Channel Separation over full bandwidth >100dB
Output Power - All channels driven,
20Hz to 20KHz, at rated Total Harmonic
Distortion (THD).
Operations Guide – DOC. 8178 2 Channel Professional Audio Amplifier: CNAMPX-2X60 5