Filter
Top Products
Crestron CNAMPX-2X60 2 Channel Professional Audio Amplifier
Configure CNAMPX-2X60 Program
DEVICE SYMBOL DROP ADDITIONAL
LIBRARY REQUIRED WHERE SETUP
Control
Systems
Desired control
system
System Views Refer to the documentation
supplied with the specific control
system for additional setup
information.
Cresnet
Control
Modules /
Cresnet
Audio
Modules
CNAMPX-2X60 System Views,
Cresnet Units
CHANGE NET ID (OPTIONAL) -
Double-click on CNAMPX-2X60
(or single-click then right mouse-
click) on CNAMPX-2X60. Select
Configure. Select NET ID then
select desired hexidecimal ID.
CNAMPX-2X60 Symbol
The diagram below shows the CNAMPX-2X60 symbol in the SIMPL Windows
Programming Manager. The two tables on the next page list the input and outputs,
respectively, and their functional descriptions.
Detail View of the CNAMPX-2X60 Symbol in SIMPL Windows’ Programming Manager
NOTE: Any software that uses the CNAMPX-16X60 symbol, including SIMPL
Windows and Crestron AppBuilder, may be used to program the CNAMPX-2X60. If
used, only 2 audio channels will be utilized and the following inputs and outputs of
the CNAMPX-16X60 symbol are ignored; Rm*_En, Rm_To_Monitor,
Rm*_Amp_Fault, Rm*_Wire_Fault, LeftSigLevel, and RightSigLevel.
NOTE: All signals listed in the following tables are DIGITAL signals unless noted
otherwise. A digital signal can be high (logic level of 1), low (logic level of 0), and
also have rising edge (when it goes from low to high) and falling edge (from high to
low) transitions. Depending upon how the symbol was created, symbol inputs may
work at the logic levels or on transitions.
Operations Guide – DOC. 8178 2 Channel Professional Audio Amplifier: CNAMPX-2X60
•
11