Filter
Top Products
Version: 6.0
19
hazardous to use. Inglenook Fireplace replacement glass can be purchased from the Country Flame
factory or through one of Country Flame’s authorized dealers. DO NOT OPERATE the Inglenook
Fireplace with cracked or broken door glass. See Figure 8 for securing points for the door glass.
FIGURE 8: DOOR GLASS REPLACEMENT
GLASS CLEANING
The Inglenook Fireplace is designed with an advanced air wash system to extend the time between
required cleaning of door glass. If the Inglenook Fireplace is operated continuously with the
combustion air damper partially or fully closed, the door glass will tend to get dirty unless the fuel,
firebox and glass are maintained at hot temperatures (see “Refueling for Best Performance”.) If the
door glass does require cleaning, use an authorized fireplace glass cleaner. Country Flame’s
authorized dealer will be happy to recommend a suitable cleaner that should be available in your
locale. Regular household glass cleaners are not effective in cleaning creosote and other gases from
the glass. DO NOT use abrasives such as steel wool or powder abrasives as they will permanently
damage the glass. Once the glass has been scratched, either expensive polishing or complete
replacement of the glass will be required. Use only approved 1400 degree Fahrenheit (°F) high
temperature fireplace ceramic glass to replace any cracked or broken glass. Refer to Appendix A for
additional information.
DOOR GASKET REPLACEMENT
Remove the doors from the unit. Place the doors, face down on a protective surface to ensure no
marring or scratching occurs during gasket replacement. To replace the Thermoglass™ knitted rope
and tape gasket, first remove all of the old material and gasket cement. Use a putty knife or other
sharp instrument to assist in removal. Use caution to prevent injury when removing old material. It
is important to ensure the area is totally clean before installing the new gasket cement and material.
The gasket must fit tight against the doorframe in order to ensure a proper airtight seal when the stove
is being operated. Apply gasket cement to the gasket channel per instructions provided with the
gasket kit. Once the cement has been properly applied, install the new gasket. Both gasket and
gasket cement are available from your authorized Country Flame dealer. The following table defines
the gasket material used in the Inglenook Fireplace:
Gasket Length Quantity Dimensions
Around glass 4.25 feet each 2 ¾” wide by 1/16” thick tape
Doorframe 5 feet each 2 3/8” rope, high density
Ash drawer 30 inches 1 ½” wide by 1/8” thick tape