Filter
Top Products
32 Chapter 6 - Basic Configuration Guide
Dual Ethernet VPN Group Configuration: IP Connection Tab
Single Ethernet VPN Group Configuration: IP Connection Tab
F. On the IP Connection Tab:
• Enter the Start IP Address. This specifies the first IP
address to be assigned to client sessions under this config-
uration. This address will be incremented by one for each
new client session, until the Max Connections number
(entered on the General tab) is reached. Since the Max
Connections value is 30 for this VPN Group, then the
Start IP Address must be the first in a block of at least 30
unused IP addresses.
For this very basic setup, it is recommended that these
addresses be on the internal TCP/IP network (i.e., on the