Filter
Top Products
Chapter 5 - Command Line Management 17
command line interface, do the following:
A. Use the configure command and set the IPAddress, Sub-
netMask, and IPBroadcast keywords in the
IP Ethernet 0 section.
B. Use the save command to save the changes to the device’s
Flash ROM.
• You may also use CompatiView from a reconfigured IP host
(if using the IP transport protocol), or anywhere on your net-
work (if using the IPX transport protocol). Instructions for
these two methods are given in Chapter 4 - CompatiView Soft-
ware Installation.
With CompatiView, basic IP parameters can be set using the
TCP/IP Routing: Ethernet 0:0 dialog box. Use the Save
to/Device option under the File menu to save the changes.
After you have set these IP parameters and saved the changes, you can
use Telnet to access the server from any node on your IP network.
Invoke the Telnet client on your local host with the IP address of the
server you wish to manage.
For more information on using Text-Based Configuration and
Command Line Management to configure your server, see Chapter 6 -
Basic Configuration Guide.