Filter
Top Products
Ovatio
n
User manual
Page 7 clearaudio electronic GmbH 2012
2.3
Very carefully place the upper bearing housing carefully onto the bearing shaft.
To avoid damage make sure you slide the upper bearing part slowly and carefully on to the polished
ceramic shaft.
2.4
Position the sub-platter carefully onto the bearing.
Please remove first the security mat on the underside of the sub-platter
(security tape for OSC - graduated collar (Optical Speed Control)).
To avoid any damage make sure you slide the sub-platter slowly and carefully on to the
bearing.
Next take the supplied belt and position it around the motor and the sub-platter. At this point the
sub-platter will be higher than the pulley. This is normal, as the CMB requires the weight of the
platter to fully engage it.
Pic. 4: Fitting the upper bearing housing
Pic. 5: Seating the sub-platter
Pic. 5.1: Installing the belt