Filter
Top Products
Ovatio
n
User manual
Page 12 clearaudio electronic GmbH 2012
On the rear (close to power supply input) of your turntable there are three setting trimmers:
- left trimmer = setting 33 1/3 rpm
(near tonearm)
- middle trimmer = setting 45 rpm
- right trimmer = setting 78 rpm
If you need to adjust the speed 33 1/3 rpm , take the aluminium screw driver (see accessories) and
turn the left trimmer until you have reached the correct speed according to the Stroboscope
Testrecord (see user manual “Stroboscope Testrecord”).
- Turning the trimmer counter clockwise = reduces the turntable speed
- Turning the trimmer clockwise = raises the turntable speed
Use the same procedure to adjust the speed for 45 rpm and 78 rpm.
Please note:
If the turntable does not reach the correct speed, the sensor or the scale ring could be dirty or
dusty.
To clean the sensor, very carefully lift off the two platters.
Clean the sensor and the scale ring with a little isopropyl alcohol and a cotton bud.
Be extremely careful to avoid any scratches on the sensor or the scale ring!
If the motor still has speed variations please contact your nearest authorized clearaudio dealer or
the clearaudio factory direct.
Now you are ready to play your vinyl records.
We wish you a lot of pleasure with your new
Ovation
- turntable.
Pic. 12: Fine speed adjustment