Filter
Top Products
Ovatio
n
User manual
Page 14 clearaudio electronic GmbH 2012
4. Special directions
The clearaudio
Ovation
does not require any extensive maintenance.
If the
Ovation
turntable is not used for a long time disconnect the motor from the mains supply.
Every two years you can lubricate (only if you will notice speed variations) the bearing of the
turntable platter with the supplied oil. In this case it is enough to put 4 or 5 drops of the oil onto the
bearing shaft.
Don’t use aggressive cleaning fluid for the
Ovation
turntable. A few drops of plastic cleaner is fully
enough.
Carefully dry all cleaned parts with a fine cotton cloth.
Please ensure that the chassis parts are only cleaned with plastic cleaning fluids.
Under no circumstances use spirit or alcohol-based fluids which will cause damage to
the surface.
You will find suitable cleaning fluids either in specialised shops or in the clearaudio online shop:
www.analogshop.de.
Please check for any damage to the power cord.
Any damage should only be repaired only by authorized personal.
A damaged power cord must be exchanged immediately!
To achieve the full clearaudio warranty, it is necessary that you fill out and send the corresponding
part of the warranty registration certificate /card back to clearaudio within two weeks (14 days) after
purchase. clearaudio can provide the warranty only if the product is returned in the original
packing.
Transportation advice:
If any transportation of the
Ovation
- turntable should be necessary, always remove the turntable
platter, otherwise serious damage can occur!
The bearing hole needs to be covered to prevent any dust from entering the bearing.