Filter
Top Products
23
Display setup
TV system NTSC
Display setup
> TV system NTSC
Superimpose On
Temporary disp. Full
Video format Auto
OSD output Both
Distance units Feet
OSD style 1
Exit
5.3.4 Balanced source: This sub menu permits you to assign the analog balanced input to any of the sources,
(AV1- AV6 and AUD1- AUD4). Use the > or the < keys to scroll through the choices. In the “Off”
setting, the balanced input is disabled.
5.3.5 Balanced routing: This sub menu gives you the choice to route the balanced input through the DSP or to use
it in “BYPASS” mode.
PLEASE NOTE THAT WHEN THE BALANCED SIGNAL ROUTING IS SET TO BYPASS, THE BALANCED INPUTS WILL
BE ROUTED TO THE LEFT AND RIGHT BALANCED OUTPUTS ONLY (via the volume control).
WHEN THE BALANCED ROUTING IS SET TO DSP, THE STEREO, STEREO96, PRO-LOGIC, PLII MOVIE,
PLII MUSIC, NEO6 CINEMA, NEO6 MUSIC, NATURAL, PARTY AND MONO MODES ARE AVAILABLE.
5.4 DISPLAY SETUP:
These settings are mainly “set and forget”, with the possible exception of OSD output. We have shipped your SSP-60 with
the “TV System” set to the correct format for your Country. If you are, however, having trouble with the picture it may be
that the wrong format is set. This is easy to correct. Using the display on the front panel of the SSP-60, navigate to the
Display setup screen and change the format to PAL or NTSC, whichever is correct for your TV and DVD player.
These displays show that you have accessed the Display setup sub-menu and highlighted TV
System. You can scan through the available choices by pressing the \/ and /\ buttons on
the remote. When the selection you wish to adjust is highlighted press the < or > key to
scroll through the choices. To leave the menu and save the settings scroll down to Exit and
press the ENTER key.
TV Display Panel Display
5.4.1 TV System: Use < or > to switch between NTSC and PAL.
5.4.2 Superimpose: Use < or > to change. “On” superimposes text over the TV picture, while “Off” allows the OSD to
completely replace the TV picture.
5.4.3 Temp. Display controls how long any On Screen Display remains present. Use < or > to change. It is possible to
set the parameter to “Full” (on all the time), “Simple” (on for a few seconds), or “Off” (disables OSD entirely).
5.4.4 Video Format can be set to S-Video output or Composite, or Auto. “Auto” automatically selects the best source
present. Use < or > to change.
5.4.5 OSD Output Use < or > to change. OSD can be applied to the Composite, or S-Video Monitor outputs, or both,
or it may be switched Off. OSD is not available on the “NO OSD” outputs.
5.4.6 Distance unit is setup in feet or meters for use in the Delay Setup sub menu.
5.4.7 OSD style changes the screen and text color if “Superimpose” is switched Off.
5.4.8 Exit returns to the Main Menu.