Filter
Top Products
13
TRIM
Press this key to cycle through a list of options which will allow you to adjust the
loudnes
s of the Subwoofer, Center, or Surround speakers, or to temporarily alter the
spectral balance of the sound in all speakers by adjusting the treble or the bass content.
Use the TRIM /\ or \
/ keys to adjust the selected parameter. This is a temporary
adjustment - when the SSP-
60 is put into Standby or is powered off the speaker levels
will revert to the settings in the Level Setup (under the Speaker Setup menu) and the
Treble/Bass settings will revert to the settings in the Audio Setup.
TRIM \/ Press this key to decrease
the loudness of the speaker previously selected with
the TRIM key, or to reduce the treble or bass content of the sound in all speakers.
TRIM /\ Press this key to increase the loudness of the speaker previ
ously selected with
the TRIM key, or to increase the treble or bass content of the sound in all speakers.
EXIT (CANCEL) Press
this key to leave the Setup Menus without saving any of the
changes you might have made.
/\ This key has two functions: Press this key to navigate through the di
fferent selections
available in the Setup Menus, while in a menu select or change a value.
ALSO: After
pressing the ZONE key
(followed by the Standby key if the Zone had not been
previously enabled), the /\ key will increase the volume at the Zone outputs.
MENU Pressing the MENU
key brings up the page of the Setup Menu you were last
using. This makes it easy to return to a setup parameter you were trying to get just right.
No mat
ter where you start in the Setup Menu, you can quickly and easily navigate to
any other section.
< This key has two functions: Press
this key to navigate through the different selections
available in the Setup Menus, while in a menu select or change a value.
ALSO: After
pressing the ZONE key
(followed by the Standby key if the Zone had not been
previously enabled), the < key will
scroll through the Audio and Audio/Video Sources to
play at the Zone outputs
ENTER The ENTER
key is used in the Setup Mode to memorize a change, or to access
a sub menu.
When you are not in a menu, pressing the ENTER key once will scan
through all of the active inputs.
> This key has two functions
: Press this key to navigate through the different selections
available in the Setup Menus, while in a menu select or change a value. ALSO: After
pressing the ZONE key
(followed by the Standby key if the Zone had not been
previously enabled), the >
key will scroll through the Audio and Audio/Video Sources to
play at the Zone outputs.
\/ This key has two functions: Press this key to na
vigate through the different selections
available in the Setup Menus, and while in a menu to select or change a value. ALSO:
After pressing the ZONE key (followed by the Standby key if the Zone had not been
previously enabled), the \/ key will decrease the volume at the Zone outputs.