Filter
Top Products
6
Unpacking and Placement
unpacking
your preamplifier
Carefully unpack your preamplifier according to the supplied instructions, and
remove all accessories from the carton.
Important! Keep all packing materials for future transport of your Classé
product. Shipping your new component in anything other than
its purpose-designed packing material may result in damage
that is not covered by the warranty.
placement As with any preamplifier, it is best to place the CP-500 centrally within your
system, since it is the hub to which all other components are connected. It
should also be located at a convenient height for both visibility and use, since
you generally interact with your preamplifier more than any other component
(changing inputs, adjusting volume, etc.).
Note that adequate clearance for the AC cord and connecting cables
must be left behind the CP-500. We suggest leaving eight inches (20
cm) of free space behind your preamplifier to allow all cables sufficient
room to bend without crimping or undue strain.
Classé recommends that the unit not be placed directly on the top surface of a
power amplifier (or any other heat source).
ventilation Your Classé preamplifier generates a certain amount of heat in the course of
normal operation. Be sure to allow three inches of clearance above it and three
inches to each side to allow heat dissipation through air circulation. Avoid
placement on soft surfaces that would restrict airflow (such as plush carpeting).
custom installations Drawings are included in this manual to facilitate special installations and
custom cabinetry (see the section
Dimensions). An optional, purpose-designed
rack mount kit is available for this product. Contact your Classé dealer for more
information.
serial number The serial number for your preamplifier is found on the rear of the unit. Please
note and record this number on the page entitled Important Safety Instructions
for your future reference.