Filter
Top Products
ADDING A STEP TO A CHASE
Action
1) Press and hold the PROGRAM button for 3
seconds to enter programming mode.
2) Press the desired CHASE (1~6) button.
3) Press the TAPSYNC/Display and the
display will display the scene and bank
number. This displays the scene you will be
adding (STEP LED must be on),
4) Use the BANK UP/DOWN buttons to scroll
through the chase and arrive at the step
number for which you would like to add or
append a scene/step to.
5) Press MIDI/ADD button and one step
number will be added to the previously
displayed step number.
6) Press the SCENE button that corresponds
to the scene to be copied.
7) Press MIDI/ADD button again to add the
new step.
8) Press and hold the PROGRAM button for 3
seconds to exit programming mode.
Notes
DELETE A SCENE/STEP IN A CHASE
Action
1) Press and hold the PROGRAM button for 3
seconds to enter programming mode.
2) Press the desired CHASE (1~6) button that
contains the scene to be deleted.
3) Press the TAPSYNC/DISPLAY button to
switch the LED display to steps.
4) Select the scene/step to be deleted using
the BANK UP/DOWN buttons.
5) Press AUTO/DEL button to delete the
step/scene.
6) Press and hold PROGRAM button for 3
seconds to exit.
Notes
Remember that we use scene and steps
interchangeably.
DELETE A CHASE
Action
1) Press and hold the PROGRAM button for 3
seconds to enter programming mode.
2) Press the CHASE button (1~6) to be
deleted.
3) Press and hold the AUTO DEL button and
the respective CHASE button then release
to delete the chase. All LED’s will blink 3
times.
Notes
Scenes will remain programmed on the controller.
Only the chase is affected.
DMX-40B User Manual 14 Revised: 2006-12-06 09:36:47