Filter
Top Products
8 Incognito KP10
The KP10 is fitted on the wall by fixing it into a standard UK 47mm depth single-gang
electrician’s back-box (pattress). All knock-outs in the back-box should be removed to provide
maximum ventilation.
Where it is desired to fit a mains lighting switch etc next to a keypad, a barrier-box or two single
back-boxes must be used (bear in mind it is not preferable to fit the keypad next to a light-switch
particularly if the faceplate styles will differ). Only a qualified electrician should attempt such
installations.
Avoid fitting the KP10 where there is line of sight to another KP10. In such situations both
keypads may pick up the same commands from a remote control and it will be difficult to control
each zone independently.
Avoid fitting the KP10 where there is line of sight to the source equipment for the system. In such
situations the source equipment may pick up the same IR commands directly as are picked up
by the keypad and sent to the source equipment. This can interfere with the remote operation of
the source equipment.
Do not fit the keypad in areas directly lit by strong sunlight or where it will be strongly lit by
fluorescent tubes. These can be sources of infra-red energy which can interfere with the remote
control operation of the system. Some plasma televisions can radiate a lot of infra-red energy
and care should be taken if fitting a KP10 near a plasma screen television. Avoid placing the
KP10 near to dimmer switches or other items, which generate a lot of electrical noise.
INSTALLATION NOTES