Filter
Top Products
16 Incognito KP10
Note: This feature is only available if the KP10
is part of a full Incognito multi-room system with
one or two Local Input Modules (LM10) fitted.
The local source selection mode will need to be
activated to configure the KP10 correctly. This
mode is only available when the Mode Switch is
set to “AH10” mode. LM10s can only be used in
this mode. Please refer to your LM10
Installation Guide for more information.
Pressing the Select left or right buttons on the
keypad allows you to rotate through all six
sources as default. However, it is possible to
allow the addition of one or two local sources by
accessing Local source selection mode. To
enter this mode press the Volume up button
simultaneously with the Power button for four seconds; the LED display will then scroll through
the sequence shown in the illustration right and described as follows:
After holding both buttons down for a short period, LED 2 will light indicating that Sources 1–6
(default) are available for selection.
Continuing to hold both keys down will light LED 3 indicating that Sources 1–6 + Local source 1
mode is available for selection.
Continuing to hold both buttons will light LED 4 indicating that Sources 1–6 + Local source 1 +
Local source 2 mode is available for selection.
LOCAL SOURCE SELECTION
2
3 4 5