Filter
Top Products
A-BUS Ready / Incognito Ready
For use with an A-BUS Ready/Incognito Ready unit (see diagram opposite) the Mode switch
MUST be in the "Standard A-BUS/Incognito Ready" position as shown below:
In this configuration the keypad is wired directly to the amplifier/receiver. A Power Supply Unit
(PS10) is also required to power the one or two keypads as shown.
To allow control of your source equipment from the remote rooms an IR emitter (IR10) is plugged
into one of the IR outputs on the rear of the unit and then attached over the IR window of the
source unit. Alternatively, on our own products that feature IR emitter Inputs, a mini-jack to mini-
jack lead can be used.
Commands received by the keypads can now be sent back to the source equipment via the
amplifier. It is then possible to control the source equipment from the remote rooms by using the
source equipment's own remote controls or through a learning remote. The Incognito LR10
Learning Remote can fully control the keypads, “learn” the source's remote controls and change
source input on the amplifier etc.
6 Incognito KP10
Std. A-BUS/
Incognito
Ready
AH10
Mode
Mode
Std. A-BUS/
Incognito
Ready
AH10
KP10-EU rear