Filter
Top Products
Incognito A-BUS keypad 17
Continuing to hold Volume up and Power buttons will light LED 5, to indicate that Off mode is
available for selection, and no source will be selected.
To select these modes, wait till the corresponding LED is lit and then release Power and
Volume up buttons.
Note: If no adjustment is made the system will automatically go back to volume
adjustment after two seconds. If “Standard A-BUS/Incognito Ready” mode is selected on
the Mode switch, the KP10 will only rotate round the main 6 sources.
REMOTE CONTROL
The KP10 can be used with the Incognito LR10 remote control,
a sophisticated learning remote which is able to learn the
codes of all the source equipment remotes. Once programmed
the user can thus use the LR10 to perform all operations from
one remote.
The LR10 is also suitable where the KP10 is to be connected to
the A-BUS Ready outputs of AV receivers and amplifiers instead
of one of our hubs as it can learn the relevant source change
commands etc of the receiver or amplifier as well as the source
equipment.
Note: Please refer to the Incognito LR10 manual for further
information.
KP10 A-BUS keypad