Filter
Top Products
AM189858_03_V.pdf December 20, 2001 13
Setting Up
Completing connections and turning on the Acoustimass
®
module
1. Plug the Acoustimass
®
module power cord into an AC power (mains) outlet.
2. Plug the multi-room interface power pack into an AC power (mains) outlet.
3. When you have checked all connections, be sure to turn the Acoustimass module power
switch on (Figure 13). It is not necessary to turn the module off after each use. The system
turns on and off automatically as it receives a signal from the Personal™ music center.
Turn the system off using the Personal music center.
Note:
Your speakers will not operate unless you complete all cable and power connections
before turning on the system.
CAUTION:
Be sure the three shipping screws on the bottom of the CD changer have been
removed before turning on the system.
Setting up the Personal music center
Set up the Personal music center after the rest of the system is connected, plugged in, and
the Acoustimass module has been turned on.
Note:
When batteries are first installed in the Personal music center, it sets up a radio-
frequency link with the closest multi-room interface.
1. Hold the Personal music center within a few feet of the multi-room interface.
2. Slide open the battery compartment on the back of the Personal music center (Figure 14).
3. Insert 4 AAA or IEC-R03 1.5V batteries, or the equivalent, as shown. Match the + and –
symbols on the batteries with the + and – markings inside the compartment.
4. Slide the battery compartment cover back into place.
5. Turn the Personal music center over and touch the screen to wake it up if it appears blank.
Press ON/OFF, FM, or any other source button to turn the system on.
If the Personal music center continuously displays “NO RESPONSE,” you need to try to
establish its link with the multi-room interface again. Hold the Personal music center close to
the multi-room interface. Press and hold MUTE for about 5 seconds until you hear a beep
and then release. After about 10 seconds, the music center should beep twice to confirm that
the link is established.
Figure 14
Installing batteries and waking
up the display for the first time
OFF
POWER
ON
RIGHT
OUTPUTS
TO
CUBE
SPEAKERS
LEFT
AUDIO
INPUT
Figure 13
Turning on the Acoustimass
module
Battery compartment cover
4 AAA
batteries
b. Turn over and wake up displaya. Install batteries
Note:
Replace the batteries when the LOW BATTERY message first appears. See “Replac-
ing batteries” on page 36. Alkaline batteries are recommended.