Filter
Top Products
ADVANCED MENU DESCRIPTIONS
The advanced setup menu allows the user to adjust the following features. An advanced menu navigational
flow chart is located on page 17 of this manual.
·
·
Maximum volume level.
·
·
IR code-set the unit will operate on.
·
·
Power on titles.
·
·
+12VDC control trigger output.
·
·
User Security
·
·
RS-232 port.
From the factory, the advanced menu is hidden from user access. To un-hide the advanced menu,
simultaneously press the UP, DOWN and ON/STANDBY buttons. “ADVANCED VISIBLE” will flash on the
screen indicating the advanced menu is unhidden. If the memory or front panel has been locked, this button
press sequence will unlock the memory.
Maximum Volume Level
The maximum volume level can be limited on the Reference 5 S2. The absolute maximum volume level
is +8dB. Line level volume level is 0dB (zero).
Product ID (Code-Set)
The product ID (IR code set) can be adjusted if operation with other B&K is gear is required. The default ID
is 002 (zero zero two). The Reference 5 S2 can be assigned to any ID (B&K code-set) between 001 and
016. This allows sixteen different Reference 5 S2’s to operate independently using different remote controls.
This feature is typically useful if multiple Reference 5 S2’s are used in the same system (whole house audio
systems). NOTE: If the code set of the preamplifier is changed, you will need a learning or programmable
remote control to operate the unit via IR. B & K offers the SR10.1 programming remote, the CK1.2 Keypad or
MZ-128 remote if different code-set operation is required. For more information on code-sets, see the B&K
CT610/310/600 Mulit-Zone Receiver User Manual.
Power On Titles
When the Reference 5 S2 powers up it will flash two lines of power on titles. These lines can be customized
for your own preferences. Each line for power on titles contains 16 customizable characters.
Control Setup (+12VDC trigger)
The single +12VDC control trigger can be programmed to be on or off depending on the dif
ferent situations
the Preamplifier Tuner is used for. The control trigger can be setup for each input of the Reference 5 S2.
Each input has the following options:
OFF = When the input is selected, the control output is off.
ON = When the input is selected, the control output is on.
PHONES = (Headphones) When the input is selected and headphone mode is selected, the
control will turn off, therefore turning off an external amplifier.
REMOTE = When the input is selected, IR will pass-through the 12VDC control out. IR will pass-
through either from a keyp
ad/IR sensor or the front panel. The emitter can be
connected to the +12VDC output and the common ground.
RS-232 = When the input is selected, the control output can be controlled with RS-232.
Typically, the +12VDC trigger will be used for controlling an external amplifier. When the 12 volts is on, the
amp is on, when the 12 volts is off, the amp is off. The amplifier must be equipped with a control trigger. All
B&K
amps are equipped with control triggers. The Preamplifier has the 12VDC trigger default set for head-
phone on all input
s.
The control will remain on during normal listening (amp on), when head
phone mode is
selected, the 12VDC control is off (amp off).
15
ADVANCED MENU