Filter
Top Products
SURROUND MODES
Your A/V System Controller provides a number of listening modes. The following table shows how your A/V
System Controller responds to the chosen surround mode setting for various types of source material. The table
assumes five full range speakers plus a subwoofer. If your speaker configuration is different from this make sure
you have performed the set up procedures described previously. When the setup is correctly performed your A/V
System Controller will automatically route audio to fewer/smaller speakers with no loss of information. If you wish
to temporarily reduce the number of speakers you are using do not repeat the setup procedure - simply choose
the appropriate surround mode.
L-M M R-M
L-R L-R
M L R LF C RF
LR LFE RR
M
M LF+LR C RF+RR
LFE
M M LF+C RF+C
LR LFE RR
M M
M M
LF+C+LR RF+C+RR
LF+C+LR
LFE
RF+C+RR
M M
LF+C+LR RF+C+RR
LFE
L RM M
M M
Mono
Stereo
Pro Logic
Dolby Digital 2.0
Dolby Digital 2.0
(Stereo)
Dolby Digital 5.1
DTS 5.1
Surround
3 Stereo
Hall
3 Stereo
Stereo
Hall
Stereo
F/R
Stereo
Stereo
Lt Rt
Headphone
L R
LF+C+LR
+LFE
RF+C+RR
+LFE
L-M M R-M
L-R L-R
L-M M R-M
L R
L-R L-R
L R
L R
L R
L R
L R
L-M M R-M
L-R L-R
L-M M R-M
L R
L-R L-R
L R
L R
L R
LF C RF
LR LFE RR
LF+C+LFE
+(LR+RR)
RF+C+LFE
-(LR+RR)
M - mono, same information on both channels of analog, PCM, or Dolby Digital 2.0 bitstream
L - left channel of stereo information of analog, PCM, or Dolby Digital 2.0 bitstream
R - right channel of stereo information of analog, PCM, or Dolby Digital 2.0 bitstream
LF - left front channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
C - center channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
RF - right front channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
RR - right rear channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
LR - left rear channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
LFE - low frequency effects channel of a Dolby Digital 5.1 or DTS 5.1 bitstream
34
p/n 12698 Rev. 9808B