Barco PGWU-62L-K Home Theater System User Manual


 
31
PGWX-62L/PGWU-62L/PGWX-62L-K/PGWU-62L-K - - 2015/07/27
4. User Controls
Color Temp
Adjust the color temperature of the image.
Cool: Apply “Cool” color temperature setting. y
Bright: Apply “Bright” color temperature setting. y
Warm: Apply “Warm” color temperature setting. y
Warmest: Apply “Warmest” color temperature setting. y
Input Balance
Adjust the gain and offset of the red, green, or blue channel of the image. This is similar to adjusting contrast, but
only affects a single color channel.
Offset: Refer to the control of color imbalance in the darker areas of the projected image. y
Gain: Refer to the control of color imbalance in the brighter areas of the projected image. y
Press the ◄ to decrease the input balance. y
Press the ► to increase the input balance. y
Aspect Ratio
Adjust the aspect ratio of the image.
4:3: The input image is resized to a 4:3 aspect ratio. y
16:10:The input image is resized to a 16:10 aspect ratio. y
Native: the original aspect ratio of the source is kept and t to screen. This is height or width whatever comes y
rst.
Auto: Automatically selects the appropriate display format. y
Timings
Adjust the horizontal position, phase or vertical position of the image.
Note: Timings function supported sources: analog computer, analog component.
Press the ◄ to decrease the horizontal position, phase or vertical position. y
Press the ► to increase the horizontal position, phase or vertical position. y
Adjust the black level or colorspace of the image.
Black Level NTSC: Set black level of NTSC. y
Format: Select the colorspace format of the source. This depending per input source. y
Aspect Ratio
Adjust the black level or colorspace of the image.
Black Level NTSC: Set black level of NTSC. y
Format: Select the colorspace format of the source. This depending per input source. y
Auto Image
Execute the auto image adjust.
Press EXECUTE to adjust the image size, phase and timing automatically. y
Force the projector to reacquire and lock to the input signal. This is useful when signal quality is marginal. After y
executing this command, the projector will enter the search status. After the signal is reacquired, the image
settings (H start, H phase, V start) will be optimized for the input signal.
Display Mode
Change the sequence and waveform of the image.
Bright: Default value. This preset provides maximum lumens output. y
Presentation: This preset provides the best possible image for presentation and computer graphics. y
Video: This preset provides the best possible image for video sources (DVD, TV, etc.) y
DICOM: This preset provides the simulated DICOM. y