Filter
Top Products
Owner’s Enjoyment Manual
The Strength of Digital
™
17
ting. If you wish to select another frequency, tap
the left or right arrow buttons until the cursor is
flashing on the number next to “Freq=”. Then use
the “+” and “-” controls to select the frequency to
which you wish to apply boost or cut.
Lvl: When the cursor highlights this part of the
screen, you can now apply boost or cut to both
channels using the “+” and “-” controls. Please
note that you do not have individual channel
control using the parametric equalizers.
Width: This control lets you select how wide
of an area each of the DQS’s parametric bands
affects. You can choose a real narrow bandwidth,
like 1/12 th of an octave or go as wide as three full
octaves.
MODE : Memories
This screen allows you to save or recall settings
to or from one of the eight memory locations.
Using the Left and Right arrows will cause the
cursor to highlight one of the following func-
tions:
Recall: When the cursor is flashing next to
this word, you have the ability to recall one of the
eight memories. Push the “+” or “-” buttons to
scroll through the memories and select a memory
to recall.
Figure 11: Memory screen
Save: Once you have made your equalization
settings, you will want to save them in one of the
eight memory locations. When the cursor is
flashing next to the word “Save”, use the “+” or “-”
buttons to select a memory location. Once you
have selected a memory location, tap either the
“Left” or “Right” button and the cursor will move
to the bottom left of the screen between “N(-)”
and “Y(+)”. Tap the (+) button to complete the
saving process or tap (-) to quit.
Please note that while you are RECALLING or
SAVING a memory, the cursor will stop blinking.
Once the processor has SAVED or RECALLED
all your settings, it will begin flashing again.
Memories Recall #1Memories Recall #1
Memories Recall #1Memories Recall #1
Memories Recall #1
Save #1 Save #1
Save #1 Save #1
Save #1