Filter
Top Products
©American Audio® - www.americanaudio.us - MCD-710™ Instruction Manual Page 27
FLIP-FLOP™
12. FLIP-FLOP™
This feature is a kind of “auto pilot
." “Flip-Flop™” mode can only function with the both drives of the
MCD-710. The "Flip-Flop" function can work with the player connected to a mixer, but it will only
work with an American Audio
® or American DJ® “Q” Start mixer. Also, the "Flip-Flop" function can
work with the cd player connected directly to speakers, without the mixer. With “Flip-Flop
™” you
can have one disc drive begin playback when the other ends. You can “Flip Flop
™” single tracks, or
entire discs
. NOTE: When the cd player is connected directly to the speakers, without a mixer,
the player can only "Flip-Flop" in single mode. It cannot "Flip-Flop" entire discs. To
"Flip-Flop"
entire discs, the player must be connected to a mixer.
FLIP-FLOP™ connection and set-up using a mixer:
1) Connect your system as described under ""FLIP-FLOP" CONNECTED TO A "Q" START MIXER
on the next page.
2) Turn the "Q" Start functions on your mixer to "on", and set your American Audio® “Q” Deck™
mixers' crossfader to the center position.
3) Load disc drives with audio discs.
4) Press the FLIP FLOP/RELAY BUTTON (20) to activate “Flip-Flop™” mode. Then press the SGL/
CTN BUTTON (7) to choose between
SINGLE mode or CONTINUOUS mode.
5) After they have both cued, press the PLAY/PAUSE BUTTON (18) on one of your drives to begin
playback.
6) If you have the cd player set to SINGLE mode, the first cds' single track will play and after it has
ended the second cds' track will immediately begin playback. If the player is set to CONTIN-
UOUS mode, the first cd will play all the way through, and then after it has ended the second cd
will start.
7) FLIP FLOP
™ will continue until you stop it or power is interrupted.
FLIP-FLOP™ connection and set-up direct to speakers:
1) Connect your system as described under ""FLIP-FLOP" CONNECTED DIRECT TO SPEAKERS"
on the next page.
2) Connect CONTROL START UNIT 1 to CONTROL START UNIT 2 on the back of the remote con-
troller
.
3) Load disc drives with audio discs.
4) 4) Press the FLIP FLOP/RELAY BUTTON (20) to activate “Flip-Flop™” mode. Then press the
SGL/CTN BUTTON (7) to choose SINGLE mode. The "Flip-Flop" function, when connected in
this way cannot "Flip-Flop" entire cds.
5) After they have both cued, press the PLAY/PAUSE BUTTON (18) on one of your drives to begin
playback.
6) Once the first cds' single track has ended the second cds' track will immediately begin playback.
7) FLIP FLOP
™ will continue until you stop it or power is interrupted.