Filter
Top Products
sents the left channels output.
31. DRIVE 1 DIGITAL OUT - This jack sends a
digital stereo out signal. Use this connection to
create near perfect copies of your disc to a Mini
disc, CD-R, or any other recording device with a
digital input.
32. REMOTE JACK - Connect the supplied 8 pin
din cable from this jack to the remote control's
channel 1 remote connector. This will allow you to
control the player functions with the remote unit.
33. VOLTAGE SELECTOR -
Because power
supplies vary from location to location a voltage
selector switch has been incorporated in the unit's
design. This switch can select a voltage input of
120V or 220V to accommodate the two major
power source. Always be sure to disconnect the
power plug before changing the voltage.
*Only dual voltage models have this swit
ch.
34. POWER CONNECTOR - This is the main
power connection. Only use the supplied polar
-
GENERAL FUNCTIONS AND CONTROLS (Cont.)
©American Audio® - www.americanaudio.us - MCD-710™ Instruction Manual Page 13
ized power cord. Use of any other power may
result in sever damage to the unit. Be sure the
local power matches the unit’s required power.
35. DRIVE 2 AUDIO OUT R & L - These jacks
send a left and right analog mono output signal.
Use these jacks to send standard audio to a
mixer or receiver. The red colored jack represents
the right channel output and white jack repre
-
sents the left channels output.
36. DRIVE 2 DIGITAL OUT - This jack sends a
digital stereo out signal. Use this connection to
create near perfect copies of your disc to a Mini
disc, CD-R, or any other recording device with a
digital input.